SPC FORD CAMBER / CASTER SLEEVE 1/4°

These popular sleeves are widely used to adjust hunting and/or bodywork on many Ford and Mazda 2/4WD trucks.

To install it, loosen and simply remove the pinch bolt from the upper ball joint.

Remove the upper circlip if there is one.

Use the sleeve extractor 77880 or 88830 to remove the existing sleeve.

To save time during alignment, use the Zero Degree 23199 sleeve to determine the initial readings, then install the correct sleeve.

Note: The sleeves adjust less on the light trucks Ford 4WD.

Adjustment range: cam./cas. ± .25 degrees at ± 3.50 degrees
Installation time: 0.5 h/side
Required: 1 per wheel